Re: Projects: Done/Not So Done
Finally did a test run with the finished Firebird at Springwater raceway on 3-26-'23. Need to fine tune it.
251 March 28, 2023 7:33 am (edited by howie March 28, 2023 7:33 am)
Re: Projects: Done/Not So Done
Now on to another project. This one is a true scale Classic NASCAR using the Pontiac Peak Antifreeze kit.
Re: Projects: Done/Not So Done
Pics??
The secondnidator
254 March 28, 2023 3:12 pm (edited by howie March 28, 2023 3:16 pm)
Re: Projects: Done/Not So Done
Doc; I have to send Bill the pictures and he installs them on the site. I thought I sent them to him this morning, but I just realized ( at about 4pm ) that I forgot to send them! First mistake I ever made in my life!
Re: Projects: Done/Not So Done
howie wrote:
Finally did a test run with the finished Firebird at Springwater raceway on 3-26-'23. Need to fine tune it.
That came out really nice. Great job.
The secondnidator
256 April 2, 2023 5:05 pm (edited by howie April 2, 2023 5:06 pm)
Re: Projects: Done/Not So Done
Back to the Classic NASCAR project. I am using a Hanna chassis #104 that has been in a LOT of races. I am installing Indy car Pro Slot rear tires for the front as they are a 1/8th. axle as the rules say 1/8th. axles only. I will trim down the tires to about .900" on the tire truer, rules say .850 minimum diameter. I will cut them to .500" width that the rules call for. I will have to cut the front axle housing by .140" on each end to get down the the maximum tracking, which is 3.250". Also the pans will have to be trimmed to make room for the tires after the axle cut.
Picture coming as soon as Bill has time.
257 August 16, 2023 8:08 am (edited by howie August 16, 2023 10:15 am)
Re: Projects: Done/Not So Done
Project Classic NASCAR continues. Beings I am going to make Bob's Classic NASCAR race in Sept. I better finish this car. It needs all the running gear from motor to guide flag. I will have to get this car on the track and see if I can get it to run ok as it has the BIG true scale size tires/wheels! At any rate it should be a fun car. I thought I had a picture of the chassis, guess not. I will send Bill a picture to add to this page. I made the motor mount out of aluminum when I still had access to a mill at work.
Bill will install a picture when he gets time. Thanks Bill.
