NASTE 2018 Point Series Championship (Page 1 of 6)

looks like i need to get a division 2 car togather

Congratulations Mitch!  Woo hoo!

Hey Mitch put a a$$ whopping on us all.That gt40 was in a class of it own, it easy of been 68 or 69 laps for the night with thing. I think you need to take it apart Mitch and look for that extra 10th that is waiting to be unleashed. Greg's cars were three lanes wide all night so trying to get around him was really tough.Jeff was a no show but Al made sure to keep the weekly smoke show going. Rico gt3 car was so fast that he once again melted down a spur gear.. Fernando little  mg car that was a rocket ship down the straight. some more tuning and he might have a jewel in the making. thanks again Al for hoisting. no racing till December there Mitch. more than enough time to find some more speed out of that ta and division one car.

Hey guys! What is Classic Sports Car Division 2?

This info is located under Race Rules in this Forum ;

Class 1 - Classic Sports Car
This class is open to classic and vintage sports cars, RTR and scratchbuilt are acceptable. Examples of cars that are legal for this class are: Revell King Cobra and Porsche 904, Ninco Classics (i.e. Porsche 356, Jaguar XK120, Corvette, Jaguar "D" Type),  old Revell 1/32 slot cars (i.e. Ferrari GTO & '65 Corvette), Carrera "D" Jag & '67 Corvette, Monogram Ferrari 275P, MRRC King Cobra & Porsche 904. This short list is not inclusive of all the possible cars, there are other brands that would fit this class with slight narrowing of the rear tires. Motors are limited to those developing no more than 18,000 RPM - refer to the Slot Car Motor List link on this site.  This class is comprised of two divisions (10/21/2015).
Division I: Elligible car's rear tire contact patch must be 7mm or less. The tire width set is that of Revell Classic cars, specifically the King Cobra and Porsche 904. Tires slightly wider than 7mm can be narrowed to meet the rule. Chassis construction must be rigid with no separate articulating pieces such as hinged side pans, motor pods, or suspension type front axle mounts.
Division II: Elligible cars' rear tire contact patch must be 8mm or less. Chassis construction may be multipiece/articulating.
Races will be run at 10 volts.

Yes there are.  I'll make some.

Official Results - NASTE 2018 Point Series Championship Race No.2 @ Rippin' Ridin' Raceway

Scalextric GT3 Class

1 Daniel    70.3 - 11 Points
2 Al    69.1 - 10 pts.
3 Jeff    68.3 - 9 pts.
4 Rico    68 - 8 pts.
5 Chris    66.4 - 7 pts.
6 Gary    65.5 - 6 pts.
7 Monte    63 - 5 pts.
8  Burns    62.2 - 4 pts.
9 Stan    61.4 - 3 pts.
10 Amy    58.2 - 2 pts.
11 Victoria    54.4 - 1 pt.

Standings After 2 Races

1st Daniel 17 Points
2nd Al   14 pts.
3rd Rico  13 pts.
4th tie Jeff Fields 9 pts.
4th tie Gary  9 pts.
6th Mitch 8 pts.
7th  tie Greg  7 pts.
7th tie Chris Kouba  7 pts.
9th Monte  5 pts.
10th Jeff Burns 4 pts.
11th Stan  3 pts.
12th tie Fernando 2 pts.
12th tie Amy  2 pts.
14th tie Chris Hammett 1 pt.
14th tie Victoria  1 pt.

Totals Corrected 2/4/'18 wb0s

mmmmmmmmmmmmmmmmmm need a up date ob da points

I remember what the results were.....

Jefff 1st Chris was 2nd and doc was 3rd think Al was 4th dont remember the rest of the field

I'll try to make the race this Thursday and get the results from Al.

No. Try not. Do... or do not. There is no try.