1 (edited by ProfessorFate November 17, 2026 12:12 pm)

Topic: Chassis Build #10

#1 Cut two equal length 3/32" square tube. #2 Place the square tube side edge on the 1" center pan and about 2.5mm from the front edge of the center pan. (as shown) #3 Lay the 3/32" square tube length about .5mm - 1mm away from the outside edge of the center section (do NOT overhang the square tube over the round tube already soldered to the center section) Hold the square tube in place with a chop stick & Solder the two insides of the 3/32" square tube to the center section. #4 Remove the center section from the side pans and place it on the hot plate. #5 Again hold the square tube in place with a chop stick & Carefully solder the outside of the 3/32" square tube to the center section as shown in picture 4 & 5 (Do not melt the solder on the round tube). #6 Clean the areas where you just finished soldering with a piece of emery cloth all the solder on the side of the center section and round tube (You should only see brass, no solder). Now clean everything with some lighter fluid and a paper towel. The center section should look like picture 6 on both sides. Clean the .063 wire with lighter fluid (Do not sand the wire) before re assembly and be sure the tube is clean and clear of any debris. Assemble everything back together on the jig.
https://i.postimg.cc/VNWxVDDx/DSC06272.jpg
https://i.postimg.cc/XqmmChYp/DSC06276.jpg
https://i.postimg.cc/VL44p28B/DSC06267.jpg
https://i.postimg.cc/YSQFKmWb/DSC06278.jpg
https://i.postimg.cc/2555TbxH/DSC06279.jpg
https://i.postimg.cc/htfwrKdj/DSC06280.jpg

Re: Chassis Build #10

thank you for posting these building pages!

Re: Chassis Build #10

jim does this chassis have the floating rear bracket?

4 (edited by ProfessorFate Yesterday 3:32 pm)

Re: Chassis Build #10

No this build does not have that design. This build is the easiest brass chassis that I know of to be built for a hardbody. There are less measurements, cutting of the brass, soldering and time on the hot plate. If you build a different style brass chassis than this one = more work. There are a lot of styles, they all get harder to build. The more parts incorporated into the chassis design, the more complected they become.

This build is for a beginner or someone who just wants to build a different style chassis than what they have.
If you look at the 1/24 Scale Modifications, slot car chassis build of the month. Scroll through and see some of the different styles of builds. This build that I am showing is one that I did a write up on (#6 Chaparral 1 ).  After you build a few chassis the easier, they are to build. You learn what is expected. Then you can move on to mere complected builds with confidence.

I have my Build Jig idea at the mechanist shop being built of what I think is my own design since I have not seen any others made like it. The jigs should be ready by Dec. 1, 2026.  This chassis jig will make building a hard body brass chassis far easier to use than what is currently available. It will not matter what style chassis you build (easy to extremely difficult). I will post them when they get finished.  Jim

Re: Chassis Build #10

Thanks Jim, i was just curious i have built quite a few myself but i always enjoy seeing other builds.