• Registered: December 31, 2018
  • Posts: 63

Topic: Newly found 64P spur gears

They are perfect! I am trying to submit a picture of the Arrowmax SL gears ... but the pic is not appearing.

http://www.naste.org/members/bill/Arrowmaxgears.jpg

Post's attachments

Arrowmax gears.JPG 697.05 kb, 1 downloads since 2020-10-07 

You don't have the permssions to download the attachments of this post.
  • Registered: January 18, 2019
  • Posts: 521

Re: Newly found 64P spur gears

Dennis, where did you source these? What did you end up using for a sleeve just a hole drilled in a piece of 3/32 tubing?

Zack

  • howie
  • Slot Racer Emeritus
  • Offline
  • Registered: March 2, 2009
  • Posts: 639

Re: Newly found 64P spur gears

Zack, I have used 3/32nd. tube as such, it works for me.

  • Registered: December 31, 2018
  • Posts: 63

Re: Newly found 64P spur gears

Got my gears from Amain hobbies in Cal.  If you want to use 3/32 axle .... you have to make your own reducer out of K&S brass 3/32 ID tubing and carefully grind out a hole for the setscrew to pass through .... then cut to length to match the gear width. When done right,  the fit is perfect.